Z1OwnersClub GB

Is there a measurement that will work instead of measuring it against the outside of the bowl

Doing it the wet method way allows for differences in float bouancy but still maintain the same fuel levels in all the bowls.
Rough set the at 25mm inverted them adjust by the wet method.

Thanks Warren I'll try that to start but will do it properly.

warren3200gt wrote:Doing it the wet method way allows for differences in float bouancy but still maintain the same fuel levels in all the bowls.
Rough set the at 25mm inverted them adjust by the wet method.

Agreed

Wet method whilst on the bench is by far the better method.
You could try drilling a tiny hole in each bowl at the correct level and you will never have to adjust them again .

You'll need one of these for the wet test. Bikerstoolbox - best value seller (and a Z1OC area rep) - https://www.bikerstoolbox.co.uk/cgi-bin ... ml#aBTB018