Thread pitch
Posted: Mon Apr 24, 2017 6:59 pm
Can someone confirm the thread pitch on the top and bottom of the engine studs, they seem to differ, ta
Z1OwnersClub GB
Kawasaki's Air Coooled Big Fours
http://www.z1ownersclub.co.uk/phpBB3/
Thread pitch
http://www.z1ownersclub.co.uk/phpBB3/viewtopic.php?f=4&t=40655
Page 1 of 1
Re: Thread pitch
Posted: Tue Apr 25, 2017 6:14 am
Anyone?
Re: Thread pitch
Posted: Tue Apr 25, 2017 6:43 am
From memory.
M10 x 1.5 (standard or course) into the cases.
M10 x 1.25 (metric fine) for the nut.
Paul
M10 x 1.5 (standard or course) into the cases.
M10 x 1.25 (metric fine) for the nut.
Paul
Re: Thread pitch
Posted: Tue Apr 25, 2017 4:03 pm
Cheers Pops, you confirmed what I was told this afternoon.